RAYMARINE EV-100 Power Pilot Hydraulic Autopilot with p70Rs, ACU-100 & Type 0.5 Pump – T70154

Description

The Raymarine EV-100 Power Pilot is a complete Evolution autopilot package for small powerboats with hydraulic steering. It combines the EV-1 9-axis sensor core, ACU-100 actuator control unit, p70Rs control head and Type 0.5 hydraulic pump. Evolution steering algorithms monitor vessel motion continuously and minimize the calibration burden associated with older autopilot systems.

Main Features

• EV-1 9-axis sensor core continuously measures vessel attitude and motion for stable heading control.
• ACU-100 actuator control unit supplies the steering drive and connects the pilot to vessel power.
• p70Rs autopilot control head provides dedicated course control and status information.
• Type 0.5 hydraulic pump supplied for the intended steering architecture.
• Application range: 50–110 cc steering cylinder capacity; final drive sizing must be based on actual steering-system specifications.

Evolution steering

The EV-1 sensor uses solid-state attitude and heading sensing to adapt steering response to sea state and vessel dynamics. Properly sized systems provide accurate course keeping with less manual calibration than traditional compass-based pilots.

Network integration

SeaTalk NG/NMEA 2000 networking connects Evolution to Axiom chartplotters, instruments, GPS and wind data. A compatible Axiom multifunction display can also provide autopilot control and navigation commands when configured correctly.

Drive sizing matters

Autopilot selection must be based on the actual hydraulic cylinder volume, steering ram or mechanical drive requirements—not boat length alone. For hydraulic systems, verify cylinder capacity and pump flow before ordering.

Installation planning

The package still requires correct power protection, SeaTalk NG backbone connectivity, steering plumbing or mechanical installation, and commissioning. A rudder-reference sensor may be recommended for some vessels and operating conditions.

What’s in the Box

• p70Rs
• ACU-100
• EV-1 sensor core
• Type 0.5 hydraulic pump
• Evolution/SeaTalk NG cabling and installation hardware
• Documentation

Specifications

• Autopilot family: Evolution
• Primary application: small powerboats with hydraulic steering
• Control head: p70Rs
• Actuator control unit: ACU-100
• Drive: Type 0.5 hydraulic pump
• Sensor: EV-1 9-axis sensor core
• Network: SeaTalk NG / NMEA 2000
• Power: 12 V DC systems unless drive/application specifies otherwise
• Sizing reference: 50–110 cc steering cylinder capacity